Stainless Steel and Vertical Wire - System 2
Product Summary
Architecturally pleasing vertical wire system. It can be used for all balustrades, regards of ground or floor height below and does not suffer from loose wires over time, or from children standing on the wires.
This modular system gives the benefits of sleek modern lines with concealed fittings.
This stainless steel and vertical wire system fully complies with strict building codes, and can be used on balconies where the floor height is above 4 metres (Horizontal wire systems cannot be used in these applications).
Pool Fencing can also be constructed with vertical wire system and meet the requirements of AS1926 (Swimming Pool Fencing regulations).
Can be installed as a complete free-standing system or fitted between existing posts and walls of any suitable materials. Wires are at 70mm spacing to ensure the maximum gap requirements of both balustrades and pool fencing is met. Maximum post spacing of 980mm centre to centre with a vertical strut fitted to the midpoint.
Applications suitable for domestic and commercial balconies, barriers and pool fences.
Key Features
- Modular design system, allowing quick and easy installation.
- Marine Grade Stainless Steel.
- Vertical barrier system with stainless steel wires at 70mm centres.
- No visible tensioners, swages, turnbuckles, fixing, etc.
- Strong continuous base plate.
- An ultimate un-obscured view.
- Very competitively priced.
- Base plate is flush mounted or with tiles, raised to allow surface water dispersal.
- Maximum un-obscured vision.
- No ongoing tensioning of wires.
Specifications
BASE | |
|---|---|
| Exposed Fittings | |
Cover Plate - Post | 445M2 Stainless Steel |
Cover Plate - Base | 445M2 Stainless Steel with pre-drilled holes @ 70mm centres |
| Non Exposed Fittings | |
Post Base Plate | 304 Stainless Steel, 100 x 65 x 6mm |
Base Rail - Angle | Hot Dipped Galvanised, 75 x 50 x 6mm with stainless steel tensioning studs |
Wire Tensioner Plate | 304 Stainless Steel |
Nut and Washer - Tensioner | 304 Stainless Steel, M8 |
POSTS | |
| Exposed Fittings | |
Post | 316 600 Grit Stainless Steel, 50.8mm diameter |
Post to Handrail Joiner | 316 600 Grit Stainless Steel flush joiner |
INFILL | |
| Exposed Fittings | |
Wire | 316 Stainless Steel, 3.2mm diameter, 7 x 7 lay wire rope |
Plug - top and bottom wire | Nylon |
Brace post and locators | 316 Stainless Steel, 19mm diameter |
TOP | |
| Exposed Fittings | |
Hand Rail | 316 600 Grit Stainless Steel, 50.8mm diameter with key holes for wire rope |
Flush Joiners | 316 600 Grit Stainless Steel, 50.8mm diameter, 90, Tee, 90 Tee and 135 Tee |
